Our moulds are hand-made and therefore the dimensions may vary from those shown. Please measure your mould before cutting your glass.
Creative Ceramics Moulds for Fusing, Slumping & Casting
The purpose of this mould is to create a clean and sharp texture in your glass. Ideal for serial work of tiles etc. If you like the floral texture to appear on a slumped bowl, use this texture mould for your first firing cycle, at or close to a fusing temperature. Then slump the glass in a subsequent firing on a shallow slumper, e.g., 958.372.
By cutting the glass smaller than the mould size, you can select specific areas of the mould for a series of slightly varying results. Instead of cutting the glass square try a circular piece instead. Pre-fuse a layer of a light transparent glass onto clear to obtain a colour shading because of the varying thickness produced by the texture.
Bullseye code: 8977
Inner Dimensions: Length: 31.5 cm, Width: 31.5 cm, Height: 0.4 cm
Outer Dimensions: Length: 32 cm, Width: 32 cm, Height: 2.8 cm
Please see Attachments tab for recommended firing cycle.
958.377
Data sheet
- Creative Ceramics Moulds
- Art Line
10165 1.850000
