Creative Ceramics Moulds for Fusing, Slumping & Casting
Casting Mould for slim pattern bars made from narrow glass strips, stringers, frit etc. To cut the pattern bar into murrine pieces, use mosaic pliers, cut nippers or if necessary a diamond saw. The murrine slices from slim pattern bars make beautiful borders on plates, jewellery and any other artwork.
Recommended Firing Chart
Please Read: This firing recommendation has been calculated for use with Bullseye Glass of average viscosity with an even thickness of 4 - 6 mm. The chart shown below is also based on the assumption that you are using a top fired kiln, e.g. Paragon GL22, GL24, BVD Flat bed kilns etc. If you are using a side firing kiln you must allow more time in the first ramp.
Please note that all our moulds are hand-made and therefore the dimensions may vary from those shown.