Creative Ceramics Moulds for Fusing, Slumping & Casting
Casting Mould for deeper pattern bars made from sheet glass, stringers, frit etc. To cut the pattern bar into murrine slices a diamond saw is required.
Beautiful artwork can be made by arranging the murrine slices to repetitive patterns or by using one murrine slice a focal component in a piece or for jewellery.
To stop the glass from running off the mould during the firing, block the ends of the mould with ceramic fibre paper or similar.
Recommended Firing Chart
Please Read: This firing recommendation has been calculated for use with Bullseye Glass of average viscosity with an even thickness of 4 - 6 mm. The chart shown below is also based on the assumption that you are using a top fired kiln, e.g. Paragon GL22, GL24, BVD Flat bed kilns etc. If you are using a side firing kiln you must allow more time in the first ramp.
Please note that all our moulds are hand-made and therefore the dimensions may vary from those shown.